Two-wavelength WDM multiplexers based on combined fiber structures
https://doi.org/10.32362/2500-316X-2021-9-4-49-55
Abstract
One of the main directions in the development of optical communication systems is associated with the use of optical fiber (ОF) for data reception and transmission. Therefore, manufacturers began to pay special attention to the creation of new brands of OF, improving their optical and operational characteristics. This makes it possible to improve existing optical fiber components that use OF as an active medium. The most widely used are two-wavelength 1 × 2 WDM multiplexers/demultiplexers designed to separate and combine optical carriers with wavelengths of 1310 and 1550 nm, corresponding to the second and third transparency windows of quartz OF. It should be noted that multiplexers and demultiplexers are the same optical devices, which are spectrally selective splitters. Such devices are distinguished by a sufficiently high level of optical characteristics at a relatively low cost of products. However, an analysis of the multiplexers produced in recent years shows that the characteristics of these devices do not sufficiently correspond to the set of modern requirements imposed by most system developers, in particular on permissible values of external influencing factors, insertion loss and the value of optical isolation of channels. Therefore, the development and research of WDM multiplexers with improved optical characteristics is relevant. One of the possible ways of optimizing such devices using new types of OF with resistance to bending losses, of which WDM multiplexers could be made. In this paper, we consider the possibilities of realizing fused single-mode multiplexers/demultiplexers based on combined fiber structures. The technology and equipment for the manufacture of these devices are presented. The optical characteristics of experimental samples of WDM multiplexers are investigated. The results of testing for the effect of temperature are given.
About the Authors
D. A. IvanovRussian Federation
Dmitry A. Ivanov, Postgraduate Student, Department of Communication Systems and Telecommunications, Institute of Radio Engineering and Telecommunication Systems
78, Vernadskogo pr., Moscow, 119454
V. I. Nefedov
Russian Federation
Victor I. Nefedov, Dr. Sci. (Eng.), Professor, Head of the Department of Communication Systems and Telecommunications, Institute of Radio Engineering and Telecommunication Systems
78, Vernadskogo pr., Moscow, 119454
References
1. Dement’ev S.G., Klyuchnik N.T., Kuznetsov V.A., Yakovlev M.Ya. Temperature stability of two-channel WDM-multiplexers based on biconical splitters. In: Konferentsiya Fundamental’nye problemy radioelektronnogo priborostroeniya “INTERMATIC – 2012” (Fundamental Problems of Radioengineering and Device Construction. Proc. of the International Scientific and Technical Conference “INTERMATIC – 2012”). Мoscow: MIREA; 2012. V. 4, p. 107–110. (in Russ.). Available from URL: https://conf.mirea.ru/CD2012/pdf/p4/26.pdf
2. Ivanov V.I. Primenenie tekhnologii WDM v sovremennykh setyakh peredachi informatsii (Application of WDM technology in modern information transmission networks). Kazan: Novoe znanie; 2012. 223 p. ISBN 978-5-89347-679-8
3. Nanii O.E. Fundamentals of the technology of spectral multiplexing of transmission channels (WDM). Lightwave Russian Edition. 2004;2:47–52 (in Russ.). Available from URL: https://t8.ru/wp-content/uploads/2012/01/23.pdf
4. SMF-28® Ultra Optical Fibers. Available from URL: https://www.corning.com/ru/ru/products/communicationnetworks/products/fiber/smf-28-ultra.html
5. Rozhdestvenskii Yu.V. Fusion fiber-optic multiplexers/ demultiplexers and their application in telecommunication systems. Foton-Express. 2004;1(31):16–18 (in Russ.).
6. Matthijsse P., Kuyt G. Influence of bending of optical fibers on their characteristics. Kabeli i Provoda = Cables and Wires. 2005;4(293):17–22 (in Russ.).
7. Dorozhkin A., Nanii O., Treshchikov V., Shikhaliev I. Low bendingloss fiber – a new life for C + L communication systems. Pervaya Milya = Last Mile. 2018;8(77):48–53 (in Russ.). https://doi.org/10.22184/2070-8963.2018.77.8.48.53
8. Besprozvannykh V.G., Mosunova I.D. Optical characteristics of single-mode bend-resistant fibers at construction in small closed objects. Innovatsionnaya Nauka = Innovation Science. 2019;1:19–23 (in Russ.).
9. Roychaudhuri P., Shenoy M.R., Pal B.P. Flame-fused optical fiber directional couplers: Fabrication and automated process control. IETE Journal of Research. 1997;43(6):433–438. https://doi.org/10.1080/03772063.1997.11416014
10. Berikashvili V.Sh., Elizarov S.G., Klyuchnik N.T., Kuznetsov V.A., Yakovlev M.Ya. WDM fiber multiplexers with reduced spectral spacing between channels. In: Konferentsiya Fundamental’nye problemy radioelektronnogo priborostroeniya “INTERMATIC – 2014” (Fundamental Problems of Radioengineering and Device Construction. Proc. of the International Scientific and Technical Conference “INTERMATIC – 2014”). Мoscow: MIREA; 2014. V. 5, p. 112–115. (in Russ.). Available from URL: https://conf.mirea.ru/CD2014/pdf/p5/29.pdf
11. Ivanov A.B. Volokonnaya optika. Komponenty, sistemy peredachi, izmereniya (Fiber optics. Components, transmission systems, measurements). Moscow: Sairus Sistems; 1999. 663 p. (in Russ.). ISBN 5-88230-080-0
12. Marcuse D. Theory of dielectric optical wave-guides. Boston: Academic Press; 1991. 380 p.
13. Hui R., O’Sullivan M. Fiber Optic Measurement Techniques. Elsevier; 2009. 672 p. ISBN: 978-0-12-373865-3
14. Berikashvili V.Sh., Dement’ev S.G., Klyuchnik N.T., Yakovlev M.Ya. Spectral selective optical splitters with increased channel isolation. In: Konferentsiya Fundamental’nye problemy radioelektronnogo priborostroeniya “INTERMATIC – 2011” (Fundamental Problems of Radioengineering and Device Construction. Proc. of the International Scientific and Technical Conference “INTERMATIC – 2011”). Мoscow: MIREA; 2011. V. 1, p. 190–193. (in Russ.). Available from URL: https://conf.mirea.ru/CD2011/pdf/p1/43.pdf
15. Dement’ev S.G., Klyuchnik N.T., Kuznetsov V.A., Yakovlev M.Ya. Singlemode wavelength-selective splitters with increased mechanical resistance. In: Konferentsiya Fundamental’nye problemy radioelektronnogo priborostroeniya “INTERMATIC – 2010” (Fundamental Problems of Radioengineering and Device Construction. Proc. of the International Scientific and Technical Conference “INTERMATIC – 2010”). Мoscow: MIREA; 2010. V. 1, p. 164–167. (in Russ.). Available from URL: https://conf.mirea.ru/CD2010/pdf/p1/36.pdf
Supplementary files
|
1. Result of manufacturing a WDM multiplexer on the FCI-0201 installation | |
Subject | ||
Type | Исследовательские инструменты | |
View
(38KB)
|
Indexing metadata ▾ |
In this paper, we consider the possibilities of realizing fused single-mode multiplexers/demultiplexers based on combined fiber structures. The technology and equipment for the manufacture of these devices are presented. The optical characteristics of experimental samples of WDM-multiplexers are investigated. The results of testing for the effect of temperature are given.
Review
For citations:
Ivanov D.A., Nefedov V.I. Two-wavelength WDM multiplexers based on combined fiber structures. Russian Technological Journal. 2021;9(4):49-55. (In Russ.) https://doi.org/10.32362/2500-316X-2021-9-4-49-55